H&S uses three - 18" 4 bar HD spiral type beaters - not augers. The beaters feed evenly and are aggressive in handling tough material. All three beaters are mounted in the head, not auxiliary panels in the box. Beater shafts are 1 1/4" equipped with greaseable bearings.

A simple trouble-free variable speed drive lets you match just the right unload speed to the crop type, load condition and blower capacity. A bronze worm gear is standard. #80 drive chain drives the main apron drive shaft. The main apron drive shaft is 1 3/4" stress proof shafting. Main apron unload rate is variable and ranges from 9" up to 12' 6" per minute.

A separate clutch allows you to start and clear the beaters before you start the main apron conveyors. The HD clutch can be used to engage just the cross conveyor, the cross conveyor and beaters, or the cross conveyor, beaters and main floor apron in any speed.

Shields are removed to show the dual belt clutch which is the primary drive source. The emergency stop mechanism is built into the drive unit and can be activated from the front, sides or rear of the box.

The twin auger utilizes two - 10" high speed cross augers equipped with hold-downs and wipers. The auger housings are poly-lined to reduce buildup.

The twin augers extend 11" beyond the side of the head. A built-in auger extension is standard and eliminates spillage between box and blower.

H&S boxes have an all steel-welded subframe.

Transport lights are standard on all H&S boxes. This is the light configuration on the front unload boxes.

All front unload boxes have a standard PTO drive while unloading off the front. Front hydraulic drive is optional.