HayBuster Balebuster 2660 (Round Bales)
With bales getting bigger and heavier, Haybuster has made the 2660 even more durable than previous models. The diameter of the rotor shaft and bearing, and conveyor shaft has been increased. The chain attachment to the slats is also more durable. The width of the table has also been increased to eliminate dead spots where material can build up. The loader forks have been moved to help center the bale while loading the bale chamber.
Notable updates:
- Taller Shredder Frame with Optional Containment Kit
- Heavier Conveyor Table Chains & Drive Shafts
- Wider Conveyor Table
- Repositioned Loader for Easy Bale Loading
- Heavier Rotor Shafts
- Optional Heavy-Duty Knobby Tires
Call for Pricing and Finance Options
Shredder Chamber with More Durable 3-Chain Slat Conveyor
The 2660 chain table comes standard with a more durable chain. This, along with the heavy duty flails and high speed rotor allows processing of bales in any condition...wet, frozen, old, new or with flattened bottoms. The conveyor is titled so it helps to keep bales positioned against the slug bars for consistent processing of hay.
Heavy-Duty Flails and High Speed Rotor
The 2660 features an oil bath chain case that reverses the direction of the in-line PTO, increasing the speed and efficiency of the rotor by 30%. Heavy-duty rotor and flails process all types of bales in all conditions.
Two Stage Bale Loader
The 2660 two-stage bale loader allows each bale to be lifted seperately without disturbing other bales. It's designed to carry a second bale to increase efficiency.
Heavy-Duty Frame
The 2660 has a heavy duty frame for strength and durability to carry today's larger, heavier bales.
Rotor Access Door
The 2660 gives you quick and easy access to the rotor for routine inspections and twine removal with the rotor access door. Two additional stripper bars can be installed on the door to reduce the length of cut.
Easily Adjustable Slug Bars
The slug bars on the 2660 are easily adjustable from a single point. The slug bar adjustment alters the amount of the hammers exposed to the hay, and is adjusted based on the type of hay, moisture content of the hay, and the coarseness/fineness of the cut desired. Also offered with an optional hydraulic adjustment.
Right Side Discharge/Deflector
Adjusting the right side deflector on the 2660 is a one-handed operation because the torsion springs support the bulk of the deflector's weight, allowing you to set the deflector to the desired position with minimal effort. The deflector can be positioned for windrow feeding for bedding or erosion control. The optional hydraulic deflector allows the operator to set the deflector position directly from the tractor cab.
Optional Grain Tank
The optional 21-bushel grain tank top dresses corn, grains and pelletized feed supplements through a 4" auger. The grain top dresses the hay for added supplement for your cattle, allowing them to clean up the ration.