H&S spreaders have a massive unitized welded frame with heavy floor supports and side stakes, wrap around steel front corners. Strong rear main beater side panels are slanted for clearance and wider spread, and then welded to the strong 5" U channel side members.

Call for Pricing and Finance Options

Front Splash Guard

Front Splash Guard is Standard

Patented H&S 2 Speed Gear Box (Model 235)

Shifting is all done in the enclosed 2 speed/beater shutoff gear box. Note the handy location of the main apron shear bolt and the sturdy hydraulic cylinder mount tube which extends all the way through the frame to the other side.

Massive Unitized Welded Frame

H&S spreaders have a massive unitized welded frame with heavy floor supports and side stakes and wrap around steel front corners. Strong rear main beater side panels are slanted for clearance and wider spread, then welded to the strong 5" U channel side members.

Reinforced Plywood

Sides, front panel and both sides of the rear hydraulic end gate use fiberglass reinforced plywood to provide for easy cleaning an minimal freeze up. The floor is plastic coasted plywood. Considerably less torque is needed to move a heavy load with this style of floor.

2-Speed Apron Drive

The 2-speed apron drive is standard equipment. An optional variable speed hydraulic drive is also available.

Beaters

The beaters have two types of paddles, blunt for widespread and sharp ripper type for cutting and shredding. The beater side wiper blades are standard.

Timken Tapered Roller Bearing Equipped

Gear box mechanisms and drive for the beater and apron are timken tapered roller bearing equipped. The beater drive gear box is 1-1 1/2 bevel gear oil bath equipped with a 4-jaw over running clutch for beater shutoff. The apron drive is a 50:1 bronze worm gear with shear bolt protection.

Oil Bath Bevel Gear Box

The strong oil bath bevel gear box that powers the beater is tapered timken roller bearing equipped. Also shown is the replaceable splined hub that welds into the main beater tube. The gear box utilizes a 4-jaw beater shutoff clutch and tractor sized spline shaft.

Easy Apron Adjustment

Adjustment for the main apron is easy, simply loosen the two side bolts and draw up the long bolt.

Apron Idler Slides

H&S uses cast special steel alloy apron idler slides instead of idler sprockets making for years of dependable service.

Variable Hydraulic Drive

An optional variable speed hydraulic drive is also available.

Optional Second Hydraulic Endgate Cylinder

An optional second hydraulic cylinder is available. The hydraulic lines are run through a 3x3 tube under the floor. The upright position of the hydraulic cylinder stroke allows the gate to lift with the least strain at pivot points. A semi-liquid hydraulic end gate is standard equipment.

Optional Top Beater

An optional top beater is available to provide load leveling and spreading of high heaped loads. Notice how both beaters have no obstructions towards the sides and rear to provide for better spreading.

Optional Rear Pan